• Search result(s) : item(s)
  • 0

    You have no items in your shopping cart.

Search by tag

You searched for the following tag

settings
Which motor timing / ESC settings should I use?
Please check the gallery above that shows the esc and motor settings tested and approved by top pilot Kan Poonnoi for the EGODRIFT Tengu 4530 motor and Hobbywing ESCs.

We'll be adding settings and detailed screens for other ESC manufacturers (Kon...
Read the FULL answer
Best pwm setting for this motor?
Usually our motors can be run on all pwm rates / frequencies. A too high frequency will usually result in the esc getting warm/hot, so the best practice is to check your esc after flight and to drop your pwm rate in case you notice any heat developin...
Read the FULL answer
What is the correct timing and frequency fo the Tengu 2520HS?
Usually the best timing for the Tengu 2520HS motors is around 8-9 degrees of timing (based on Hobbywing) and a PWM rate of 32 should work just fine. The best way to check if the timing for your motor and setup is correct, is by measuring the temperat...
Read the FULL answer
What frequency and pwm do I run the 4025 1050kv please
Usually our motors can be run on all pwm rates / frequencies. A too high frequency will usually result in the esc getting warm/hot, so the best practice is to check your esc after flight and to drop your pwm rate in case you notice any heat developin...
Read the FULL answer
What does 12N10P mean? I need this for setting up my YGE 205 telemetry capabilities
This abbreviation refers to the layout / winding scheme of the motor. The first part (N) translates to the number of arms (wire wound poles) on the stator, whereas the second part shows the number of magnets (permanent magnetic poles) on the rotor...
Read the FULL answer
What timing should I use on the 4020 1050kv motor using a 120a hobbywing esc?
Our HS series motors tend to run best on a rather low timing, and we usually recommend starting at 9 degrees (on Hobbywing), and to test fly the heli (and measure the temperature with a temp gun after flight). If necessary, you can adjust (fine tune)...
Read the FULL answer
Motor timing for 4020 1050kv with hobbywing esc
Like with all Tengu HS models, we recommend to set the timing (advance) to around 9 degrees to start, and adjust in +/-1 steps if necessary. Please measure the temperature after the flight to check if the settings are fine.

Side note: The motor ha...
Read the FULL answer
I just recieved a 3220HS/900kV - how many poles do this motor have? What timing do you recommend?
The 3220HS is a 10 pole motor and like with most Tengu HS models, we recommend to set the timing at 9 degrees, test it in flight and adjust in +/-1 steps if necessary.
Read the FULL answer
What is the recommended timing for this motor?
Like with all Tengu HS models, we recommend to set the timing (advance) to around 9 degrees to start, and adjust in +/-1 steps if necessary. Please measure the temperature after the flight to check if the settings are fine.

Side note: The motor ha...
Read the FULL answer
Back to Topics